Open up your Curv Vapor Kit. Inside you will find:
Before using your Curv Vapor for the first time, you will want to charge it for several hours to ensure you get the most out of your battery. Connect your USB Charger to the USB port on the side of the Curv Vapor. Then plug the USB into any USB port on a laptop or computer, or any USB Wall Charger (5V 1A). Then allow to charge for several hours. Glowing red during charging, the LED light on the side near the USB will turn green once fully charged.
If the power is too low when heating, the system will automatically stop and enter Curv Standby Mode (LED will flash 5 times). And the Curv will automatically shut off after 5 minutes without any operation to help conserve battery life.
Grab your dry herb and a grinder. Finely grind your product. Swivel open the heating chamber cover. Then gently load in your product into the heating chamber. Swivel close the cover. Done!
Depending on the type of Dry Herb you are using (sticky/wet/dry) along with personal preference, you will need to customize your heating level. Start by pressing the heating button once to enter Curv Standby Mode (LED will be White). Then hold down the power button to set your temperature. You will see different colors for the 3 different temperatures: Red for 380°F, Green for 400°F and Blue for 440°F.
The LED will flash during the heating process then once the heating chamber has reached the precise temperature the LED will remain solid.
Once your heating chamber is full of vapor, you can either enjoy your Curv with the mouthpiece on or off, hitting the glass airway instead. Simply remove the mouthpiece and take a hit directly from the glass airway.
Take slow draws to enjoy the 100% pure, clean vapor taste.
To get the most out of your new Curv Vapor, you will want to make sure to take care of it. We recommend cleaning your heating chamber every couple of weeks by simply wiping it down with a cloth & a little rubbing alcohol to clean off any deposits that may build up. Because you are not burning any product, you should not have any resin buildup. But with very sticky product, you may have residue that needs to be cleaned out every so often.
The mouthpiece should also be cleaned periodically, wiped down with soap and water or rubbing alcohol for any residue.
We recommend cleaning the glass airway after each use. Simply insert the pipe cleaner into the glass airway and gently clean out any residue. Please do not attempt to pull out the glass airway as you may break it. If you need to clean this piece, please contact Customer Support at 877-418-8273 for assistance.